OMNI NXT F7 Flight Controller Board and Typhoon 4in1 S ESC 4x30A Race Verison for quadcopter drone | Электроника

Uses: vehicles and radiographic toys
Four wheel drive properties: assembly
Tool Supplies: Assembly Category
Suitable for aircraft type: helicopter
F7 MCU processors
Two gyros onboard: MPU6000 for sampling up to 8khz and ICM20608 for sampling up to 32khz
Supports 3-6S Lipo
Built-in 5V 1A BEC output (Buck)
Built-in 8V 1A BEC with LC filter output for the camera and VTX (Buck)
STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD
More caps to reduce power noise
Port for easy connection to Airbot 4-in-1 esc (SH1.0 8P)
Solder pads added for SmartAudio and Camera Control
Typhoon 4in1 S ESC
BB21 MCU, 48Mhz Runs BLHELI_S J_H_xx firmware
Supports 3-6S lipo input
4PWM input
Current and Voltage output
NO BEC
Supports oneshot / Multishot / Dshot PWM
Supports damped light
NO External capacitors needed
Different frame will cause different test result with the current, we rated it as the mid-value, in your frame, the current may higher or lower, there is no Guarantee, if you can get same result in your frame.
colour: blue
Material: PCB
size: 35x35mm
Package Contents:
1xTyphoon S Racer 4in1 Electronic governor
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.