NPT 3/4" USC-HS43TB Hall Effect Water Flow Sensor 2-45L/min Threaded Ends Repeat Error 1% Brass Turbine Flowmeter for Purifier |

2 meters cable NPT 3/4" USC-HS43TB Hall Effect Water Flow Sensor 2-45L/min Threaded Ends Repeat Error 1% Brass Turbine Flowmeter for Purifier

24V:can work with 3.3-26.4V input voltage.

Model: USC-HS43TB

Application:

Water heater, washing machine, boiler, electromagnetic water heater, water dispenser, water purifier, R.O. machine, U.F. machine, coffee machine, water machine, water machine control, water control machine, beer machine, beauty equipment, shower equipment, electrolytic water machine, energy engineering, heat pump,IC meter, steam equipment, irrigation equipment, water system, campus card self-service sale (sell) water machine, washing machine, automatic washing equipment, water treatment equipment, water dispensing equipment, cooling system, circulation system, intelligent toilet (toilet), bidet, mechanical equipment, heating equipment,  Pharmaceutical (agents) equipment etc.

Calculation Formula:F=8.3Q   Q=L/Min   Features: 1.       brass body, sus304 shaft and cir-clip, PA66 nylon turbine. 2.       Intubation design of inlet and outlet pipe, easy connection and operation; 3.       Imported Hall IC from Japan, stable and reliable; 4.       Flow Range: 2-45L/min; 5.       working voltage: 3.3-26.4V(24V input, 23.5V high level output) 6.       rated voltage: DC5V; 7.       Output voltage(rated: DC 5V); High level 4.5V and above; low level 0.5V and below 8.       Pulse output duty cycle: 50+-10% 9.       Insulation resistance: 100M Ohm and above; 10.     Tightness: Seal up all the holes, and inflate with 0.8MPa water, after 1 minute, no leakage and deformation; 11.      -20-60 centigrade; 12.      Max Pressure: 1.7Mpa 13.    Electrical Strength: AC500V 50Hz. 14.    Wire length: regular 15cm/32cm, other length can be tailor made against request. 15.     End connection: SM2.54 Plug 
Note: 
1. When magnetic material is close with the sensor, its characteristics may vary. 
2. In order to avoid particle debris, the sensor must be installed after a filter. 
3. The flow sensor can be installed in any direction. IT has to avoid strong vibrating and shaking environment, so as not to affect the accuracy.